Black Box IC108A Przewodnik Instalacji Pobierz pdf (Strona 27)

Hardware Installation Guide

revision 1 — 169

Step 1: Establish a serial connection with ETHLAN

With the power OFF on the UDS device, establish a serial communication from the UDS to the PC’s serial

communication port, for example, using HyperTerminal.

1. Start HyperTerminal.

2. Select the correct PC port and change the communication settings to 9600 baud, 8 data bit, and parity

none.

3. Hold down the <X> key on your keyboard and plug the power back into the UDS device. This will

allow you to enter the setup mode on the ETHLAN.

4. At this point, type <Enter>, and follow the onscreen instructions for programming.

5. When prompted for a password, please use UDS and press <Enter>.

Step 2: Establish network communication

1. Determine the IP address that will be programmed into the UDS.

2. Enter the Server Configuration menu by typing 0 and hitting <Enter>.

3. Follow the onscreen instructions and enter all your necessary network settings.

4. Refer to the manufacturer manual when entering the subnet mask information. Note: for standard class

C subnet, enter an 8.

5. Once you have finished entering all your custom network settings, type a 9 at the prompt. This will save

all your network configurations and reboot the UDS.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 33 34 35

Brak uwag

Black Box IC108A Przewodnik Instalacji Strona 27