Black Box LWN600CM-1 Podręcznik Użytkownika Strona 127

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 192
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 126
724-746-5500 | blackbox.com
724-746-5500 | blackbox.com
Page 127
Chapter 9: Common Configuration Examples
To-Access: (nothing)
Default Action: Deny
Expand QoS Settings, and enter the following:
Rate Control & Queuing Policy: QoS-Guests
This is the policy that you created in "QoS Rate Limiting.The SmartPath AP applies these rates and scheduling to users
that belong to this user profile on an individual basis.
CAC Guaranteed Airtime: 0 (default)
Call Admission Control (CAC) monitors the SmartPath AP resource load and airwaves for congestion, and then deter-
mines whether to allow additional VoIP calls using Session Initiation Protocol (SIP) or Vocera services to initiate on that
SmartPath AP. If the SmartPath AP and airwaves are already overused, then a new caller is not permitted to start a call.
Because this user policy will not be applied to voice traffic, it is unnecessary to set this.
Policing Rate Limit a/b/g mode (0-54000 Kbps): 2000
Policing Rate Limit 11n mode (0-2000000 Kbps): 2000
The maximum traffic policing rate for the entire user profile is the same as that for an individual user. By keeping the two
rates the same, a single on-line user is not restricted to a smaller rate than that of the profile to which he or she belongs.
(These rates can be the same as or greater than the individual user rates.)
Setting a rate limit of 2000 kbps provides guests with a basic amount of available bandwidth without interfering with the
bandwidth usage of other users, such as employees.
Scheduling Weight: 5
The weight defines a preference for forwarding traffic. It does not specify a percentage or an amount. Its value is relative
to the weights of QoS schedules in other user profiles in the same WLAN policy.
Because wireless access for guests is mainly a convenience and not a necessity, you assign it a weight that is low in
comparison to the weights of other user profiles to give guests the lowest priority. In this example, 5 is used. Because
this setting is a relative weight, modify it as necessary based on the weights of the other user profiles present.
NOTE: Although SmartPath APs apply policing at all times, they only apply scheduling weights when usage is at maximum
capacity.
SSID
You can provide visitors with secure but unregistered network access by issuing them a preshared key to use when associating
with the guest SSID. A receptionist can provide visitors with the preshared key along with access instructions upon their arrival, as
shown in Figure 9-16. This approach provides visitors with secured network access by using WPA or WPA2 with preshared keys
and TKIP or CCMP (AES) encryption.
Przeglądanie stron 126
1 2 ... 122 123 124 125 126 127 128 129 130 131 132 ... 191 192

Komentarze do niniejszej Instrukcji

Brak uwag