Black Box V5.1 Instrukcja Naprawy Pobierz pdf (Strona 9)

Euro MotoElectrics, 25958 Genesee Trail Road PMB 321 Golden, Colorado USA 80401 EDL-IGN Page 9 of 43

www.EuroMotoElectrics.com info@euromotoelectrics.com Tel: 1-303-526-0901

EnDuraSpark Electronic Ignition

Installation & Troubleshooting v5.1

With a 6mm Allen wrench, remove the center bolt holding

the EnDuraLast rotor to the crankshaft. Often this can be

removed by “jerking” the wrench without holding the motor

from turning.

If the bolt won’t break loose, place the transmission in gear

and apply the rear brake. This will keep the engine from

turning.

Loosely assemble the timing wheel, part #3 (in

the “Inventory” parts explosion) on the wheel

hub, part #6, so the wheel can rotate freely on the

hub. The wheel goes with the “N” and “S” stamps

facing outward.

Insert the new longer rotor center bolt, part # 14 in the wheel hub and install the assembly on the

rotor. Tighten with a torque wrench with a 5 mm Allen bit to 14 ft-lbs (168 inch-lbs). Do not over

tighten!

Step 9: Install Wheel Hub on New Rotor Bolt

Wheel Hub

Wheel Timing Center

Hub Wheel Bolt

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 42 43

Brak uwag

Black Box V5.1 Instrukcja Naprawy Strona 9